The Writer's Lifestyle

A scratchy fountain pen nib is one of the most common owner complaints — and one of the most fixable. Before assuming the pen is defective, know that most scratchiness comes from three causes: minor tine misalignment, small burrs on the tipping, or writing at an angle the nib wasn't tuned for. All three are fixable at home in 15 minutes with tools that cost under $10. This guide walks through fountain pen nib smoothing safely — diagnosis, tools, technique, and when to stop and swap the nib instead. Every step is tested on the steel-iridium nibs used across the Wordsworth & Black line. The 18K gilded nib on the Majesti Gold requires more care and should typically be sent to service rather than smoothed at home. Key Takeaways Most "scratchy" nibs are actually writing-angle mismatches, not damaged nibs. Try adjusting your grip before touching the nib. Real nib smoothing uses micromesh sheets (12,000 grit or finer) — never sandpaper, never nail files, never anything abrasive. $5–$10 for a small starter set. Steel-iridium nibs (Crest, Erudite) tolerate home smoothing well. Skip home smoothing on 18K gilded nibs (Majesti Gold) — send those to service. The alternative to smoothing: swap the nib. A Wordsworth & Black spare nib installs in 30 seconds and costs less than most micromesh sets. Stop smoothing at the first sign of improvement — over-smoothing produces a "buttery" nib that has no feedback and encourages sloppy handwriting. Diagnose Before You Smooth Not every scratchy feel is a nib problem. Rule out these first. Writing Angle Mismatch Fountain pen nibs write best at a specific angle — usually 40–55 degrees from the paper. Steeper angles catch the paper on the tipping edge; shallower angles scrape the shoulder of the nib. Try rotating the pen 15 degrees in your grip and see if scratchiness disappears. Paper Quality Cheap paper (under 70 GSM) feels scratchy with any nib because the fibers grab at the tipping. Test the pen on 100+ GSM journal paper. If the paper feels smooth on the journal but scratchy on office paper, the paper is the problem. Ink Choice Dry-flowing inks feel scratchier than wet-flowing ones because there's less lubrication between nib and paper. If you've recently switched inks, try a different bottle from the Wordsworth & Black bottled ink line — Royal Blue and Racing Green both flow slightly wetter than Mysterious Black. Tine Misalignment The two halves of the nib (tines) should meet symmetrically at the tipping. If one tine sits higher than the other, the nib catches asymmetrically on the paper — feels scratchy. Look at the nib under magnification (phone camera works) — visible misalignment is a real problem, not a scratchy-feel problem. Ink Flow Issue Masquerading as Scratchiness A poorly-flowing nib (dried ink partial clog) can feel scratchy. Flush the pen with cold water for 30 seconds and retest. If the "scratchiness" disappeared, it was flow, not tipping. Tools You'll Need Essential Micromesh sheets in grits 3200, 6000, 8000, and 12000. A starter pack from any hobby or fountain pen supplier costs $5–$10. Sacrificial paper — a few sheets of quality writing paper for testing after each smoothing pass Cold water and paper towels for cleaning ink residue between passes Good light — direct, bright, ideally with a magnifier for close inspection Optional but Helpful 10× loupe or phone camera with macro mode — for inspecting the nib tipping Brass sheet — a smoother alternative to fine micromesh for final polish Small brush — for clearing micromesh dust from the nib slit Never Use Sandpaper of any grit — too abrasive for iridium tipping Emery boards or nail files — same problem Dremel or motorized tools — removes material too fast Toothpaste — abrasives in toothpaste vary widely and can damage tipping The Smoothing Technique Step 1: Empty and Clean the Pen You don't want ink on the micromesh or all over the paper. Remove cartridge or converter, flush the section with cold water, dry thoroughly. Step 2: Test-Write to Identify the Rough Spot Reinstall a cartridge (or leave the section dry — just write a shape). Write figure-8s slowly on quality paper, feeling for exactly where scratchiness occurs — on the downstroke, cross-stroke, or when reversing direction. This tells you which part of the tipping needs work. Step 3: Start with the Finest Grit That Works Counter-intuitive but important: start with the finest micromesh (12000 grit) first. If it improves the nib, great — stop there. Only move to coarser grits (8000, 6000) if 12000 doesn't fix it. Never start with 3200 unless there's visible damage. Step 4: The Smoothing Pass Place the micromesh sheet flat on a hard surface (desk, book). Write figure-8s on the micromesh using the pen without ink. Light pressure — the same you'd use writing on paper, not more. 10–15 figure-8s per pass. Then flip to a fresh area of micromesh and do 10–15 more. The used surface accumulates iridium dust and stops smoothing effectively. Step 5: Wipe and Test Wipe the nib with a paper towel to remove micromesh dust. Reinstall the cartridge. Test-write on quality paper. Feel for improvement. Step 6: Repeat or Stop If improved but still slightly scratchy: repeat with the same grit for another pass. If unchanged: move to the next coarser grit (12000 → 8000 → 6000). Stop at the first sign of improvement. Over-smoothing produces a nib with no feedback — smooth as glass but no character. This is worse than slightly scratchy for most writers. Step 7: Final Polish (Optional) After micromesh smoothing, some owners use a brass sheet or plain paper for a final polish pass. Write figure-8s on brass or a smooth paper. Adds a final micro-smoothing without removing material. Nib Smoothing Grit Progression Micromesh Grit Progression Start: 12000 grit Finest · Try first · Stop if works Escalate to: 8000 grit Medium · Only if needed Only if: 6000 grit Aggressive · Rare Never start with: 3200 Repair-only Final polish (optional) Brass sheet or plain paper Start with the finest grit. Escalate only when needed. Over-smoothing is worse than slightly scratchy. When to Swap Instead of Smooth Sometimes smoothing isn't the right answer. Signs that a nib swap is better: Visible Damage A bent tine, cracked tipping, or asymmetric wear can't be fixed by smoothing. Swap with a Wordsworth & Black spare nib — 30 seconds, no tools required. You've Already Smoothed and It's Still Wrong Two passes with escalating grits and no improvement means the nib has a problem smoothing can't fix. Swap. You're Nervous Home nib smoothing is safe with light pressure and fine grits, but if the process makes you anxious, a swap is the low-stress alternative. Spare nibs cost less than most micromesh starter sets. 18K Gilded Nib The Majesti Gold's 18K gilded nib is precision-tuned for its flex. Home smoothing risks damaging that tuning permanently. For gold nibs, swap or send to professional service. Preventing Scratchiness in the First Place Match Nib to Paper Fine nibs feel smoother on cheap paper than Broad or Stub nibs. If you write on unpredictable paper, choose EF or F. Match Nib to Grip Test your normal writing angle when trying a new pen. If a pen feels scratchy immediately, try rotating the grip before assuming the nib is defective. Don't Loan the Pen Every writer's grip retunes the nib slightly. A borrowed pen returns slightly less smooth than it left. Keep the fountain pen personal. Flush Regularly Dried ink in the feed can cause partial flow issues that feel like scratchiness. Regular 4–8 week flushes prevent this. Store Carefully Dropped pens bend nib tines. Store nib-up in a pen loop, sleeve, or case. Never loose in a bag with keys and coins. Frequently Asked Questions Is home nib smoothing safe? Yes — with fine micromesh (12000 grit or finer), light pressure, and steel-iridium nibs. The risks are real (over-smoothing, gold nib damage) but manageable with technique. How often should I smooth a nib? Ideally never after initial tuning. A well-smoothed nib should stay smooth for years of daily use. If you're smoothing every few months, something else is causing the roughness (paper, ink, grip). Can I smooth a nib to change the nib size? Not really. Smoothing removes tiny amounts of material to polish the surface — not enough to change line width meaningfully. To change nib size, swap the nib. What does a properly smoothed nib feel like? Smooth glide across paper with subtle feedback — you can feel the pen writing, but the writing doesn't feel scratchy. If the nib feels like glass with zero feedback, it's over-smoothed. Should I smooth a new pen straight out of the box? No. Give any new pen a week of daily writing first — the nib self-tunes slightly to your grip. Only smooth if scratchiness persists after that adjustment period. What if I damage a nib during smoothing? Swap it. A Wordsworth & Black spare nib installs in 30 seconds. The pen is back in service before your next writing session. Are there professional nib smoothers? Yes — nibmeisters (nib specialists) offer professional smoothing and grinding services. Costs $30–$100 per nib depending on service level. Worth it for premium pens or if you're uncomfortable smoothing at home. Final Verdict A scratchy fountain pen nib is usually fixable in 15 minutes with fine micromesh and light pressure. Start with 12000 grit, escalate only when needed, and stop at the first sign of improvement. For steel-iridium nibs across the Crest Set and Erudite Collection, home smoothing is safe and effective. For the 18K gilded nib on the Majesti Gold, professional service or a nib swap is the safer path. The alternative that eliminates all risk: spare nibs. A 30-second swap costs less than most micromesh starter kits and gets the pen writing without any tools or technique. Keep a spare nib in the pen case regardless. It's insurance against smoothing mistakes, bag drops, and any other nib event that would otherwise take a pen out of service. → Shop Spare Nibs